I have successfully read Motorola MC68HC08AZ32 chip data by using Xprog-M v5.55 ecu programmer. Pinouts and operations are attached below.
Vauxhall Meriva 1.7 (z17dth)
Why i need ECU programmer?
Meriva 1.7 has engine failure. I have fixed the engine and its running normal now.
I have the airbag light in the dash.
Two airbags has deployed, so that’s why I have mounted resistors to trick the ecu, BUT!
This ecu can only be used one time.
And Xprog-m is the most populous in my post for ecu programmer suggestion.
How to connect Xprog to the chip MC68HC08AZ32A?
Mask sets: 0J66D
Oscillator: 58, 59 pin
EEPROM: 0x0800 – 0x09FF
How to read Motorola MC68HC08AZ32 with Xprog-M?
I solder the mcu back to the board and added the 8 wires, without desoldering all chip.
and read Motorola MC68HC08AZ32 with Xprog-M 5.55 (UPA USB programmer also ok),
then put damp here and get new damp clear, without crash data.