Kess V2 clone fw4.036 “Invalid protocol file” solution

I have kess v2 master clone software 2.08/2.13 firmware 4.036 and if selected VAG siemens PCR2.1 or siemens simos 10.12 write me message “Invalid protocol file” . I have tested ecu MED17.5.5 and Jaguar simens SID201 reading and writing normally…

I use with kess v2 fw4.036

Before and after

kess-v2-PCR21_after

kess-v2-PCR21_before

Customer solutions:

1.I have today identical problem not work pcr2.1 i format SD-card and put again files on the SD card , now works like charms.

2. Maybe some steps are not needed but i do like this:
Do all steps to firmware update -> Done -> Connect kess to PC agane -> run THIS program with protocol corrections -> (Then need push two button) PUSH “KESS protocol Update Loader” and wait ~ 5-10 sec until winrar end working ->PUSH KESS protocol update start(program will start and update your sd card agane) -> all done.

3.I have solved invalid protocol by formatting kess v2 sd with some format program and not windows. Now all ok. The program i used is called “EASEUS partition master”.

Advertisements

About eobd21

I am a car lover and like to repair car by myself, and know more info about car diagnostic tool and other obd2 tools, share these info with everyone.
This entry was posted in car ECU programmer and tagged , . Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s